Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Uplander Base, 3.9 M >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.9L - Introduction (2 Of 2) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of CMP Sensor And Components
    GM1599076Courtesy of GENERAL MOTORS CORP.
  1. Replace the O-ring if damaged, lubricate the NEW O-ring with clean engine oil.
  2. Install the CMP sensor.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the CMP sensor bolt and tighten to 10 N.m (89 lb in)  .
  4. Connect the CMP sensor electrical connector.
  5. Install the power steering pump. Refer to Power Steering Pump Replacement .
scientia non olet · About Mike's Workshop Manuals