Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Uplander Base, 3.9 M >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Cellular, Entertainment, And Navigation >> Repair Instructions >> Digital Radio Receiver Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Radio Wiring Harness
    GM955738Courtesy of GENERAL MOTORS CORP.
  1. Install the XM digital radio receiver to the receiver bracket.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the radio receiver nuts and tighten to 4 N.m (35 lb in)  .
    3. Fig 2: Identifying XM Digital Radio Receiver
    GM955754Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connectors and the antenna connectors to the XM radio receiver.
    4. Fig 3: View Of Knee Bolster Assembly
    GM318206Courtesy of GENERAL MOTORS CORP.
  4. Install the left I/P insulator. Refer to Instrument Panel Insulator Panel Replacement .
  5. Perform the setup procedure for the digital radio receiver. Refer to Control Module References for programming and setup information.
scientia non olet · About Mike's Workshop Manuals