Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Uplander Base, 3.9 1 >> Repair and Diagnosis >> Body & Frame >> Seats >> Power Seats >> Repair Instructions >> Sit-N-Lift Remote Control Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Remote Control
    GM1368565Courtesy of GENERAL MOTORS CORP.
  1. Install the remote control and the cord to the seat base.
    2. Fig 2: Locating Electrical Connector
    GM1368543Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector to the seat base.
    3. Fig 3: View Of Right Side Upper Trim Panel
    GM1368170Courtesy of GENERAL MOTORS CORP.
  3. Install the rear trim panel to the seat base.
  4. Connect the retainers holding the cable to the upper trim panel.
  5. Install the right side upper trim panel to the seat base.
  6. Test the seat for proper operation.
scientia non olet · About Mike's Workshop Manuals