Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Uplander Base, 3.9 1 >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Vehicle Access >> Repair Instructions >> Sliding Door Lock Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Sliding Door Lock Module Mounting Components
    GM1480590Courtesy of GENERAL MOTORS CORP.
  1. Position the lock module to the inner door.
  2. Connect the lock rods (4).
  3. Connect the electrical connector (3).
  4. Connect the door lock release cable to the lock module.
  5. Position the lock module to the door.
  6. Install the lock module screws (1).
    7. CAUTION: Refer to Fastener Caution .
  7. Install the forward mounting bracket screws and tighten.
    • screws, in sequence as shown, to 10 N.m (89 lb in)  .
    • top screw (1) to 10 N.m (89 lb in)  .
    8. Fig 2: Identifying Rear Latch Rod And Insulator Guide
    GM1480598Courtesy of GENERAL MOTORS CORP.
  8. Ensure the rear latch rod is secured into the sliding door insulator guide.
  9. Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
  10. Close the sliding door.
    11. NOTE: By installing the 15A fuse, the low current logic power will be restored to both the LH and RH PSDMs and the PSDs will be operational. However, both PSDMs will have to learn the full open and full closed positions of the PSD. Refer to Rear Side Door Actuator Control Module Programming and Setup .
  11. If equipped with a power sliding door, enable the PSD system by installing the PSD 15A fuse into the I/P fuse block.
scientia non olet · About Mike's Workshop Manuals