Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Traverse LS, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (Engine Controls And Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Mass Airflow Sensor with Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 GMC Acadia, 2011 Chevrolet Traverse, and 2011 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Mass Airflow Sensor/Intake Air Temperature Sensor
    GM1858081Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF/IAT sensor seal (3) onto the MAF/IAT sensor.
  2. Install the MAF/IAT sensor (2) to the air cleaner assembly.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the MAF/IAT sensor screws (1).

    Tighten 

    Tighten the screws to 4 N.m (35 lb in).

  4. Connect the engine wiring harness electrical connector (4) to the MAF/IAT sensor.
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
scientia non olet · About Mike's Workshop Manuals