Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Engine Control System & Fuel System - 3.6L - DTC P0638 To DTC P2635) >> DTC P2534 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that DTC P0562 is not set.
  2. Ignition OFF, disconnect the harness connector of the FPCM.
  3. Ignition ON, test for greater than 11 volts between the IGN voltage circuit terminal 15 and ground.
    • If less than the specified voltage, test the IGN voltage circuit for a short to ground or an open/high resistance. If the circuit test normal and the ECM - IGN fuse 58 is open, test the voltage circuit for a short to ground. If the circuit tests normal, test or replace the Run/Crank relay.
  4. If all circuits test normal, replace the FPCM.
scientia non olet · About Mike's Workshop Manuals