Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Engine Control System & Fuel System - 3.6L - DTC P0638 To DTC P2635) >> DTC P0650 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the scan tool MIL circuit status parameters. Each of the MIL circuit status parameters should display OK or Not Run.
  2. Ignition ON, command the MIL ON and OFF with a scan tool. The MIL should turn ON and OFF as commanded, and the MIL circuit status parameters should continue to display OK or Not Run in each commanded state.
  3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About Mike's Workshop Manuals