Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Immobilizer System) >> Diagnostic Information and Procedures >> DTC B302A >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. With a master vehicle key, turn the ignition ON.
  2. Observe the security indicator. After approximately 10 minutes, the indicator will turn off.
  3. Turn the ignition OFF and wait 5 seconds.
  4. Repeat steps 2-4 two more times for a total of 3 cycles or 30 minutes.
  5. With a master vehicle key, turn the ignition ON. The start disable will now be cleared.
  6. Using the Red Emergency Button, notify the advisor that the Ignition Block on the vehicle has been cleared and to update the account status.
scientia non olet · About Mike's Workshop Manuals