Power Steering Pump Pulley Replacement

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Power Steering Pump Pulley

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the power steering pump. Refer to Power Steering Pump Replacement .
1	Power Steering Pump Pulley Procedure Use the J 25034-C: remover for Buick, GMC, and Chevrolet or the SA9162C: remover/installer for Saturn to remove the power steering pump pulley. Use the J 25033-C: installer for Buick, GMC, and Chevrolet or the SA9162C: remover/installer for Saturn to install the power steering pump pulley. Ensure the axial tolerance of the power steering pulley on the shaft is within 0.25 mm (0.010 in). Special Tools J 25033-C: Pulley Installer J 25034-C: Pulley Remover SA9162C: Power Steering Pump Pulley Remover/Installer For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Preliminary Procedure:
Remove the power steering pump. Refer to Power Steering Pump Replacement .

Power Steering Pump Pulley

Procedure

Use the J 25034-C: remover for Buick, GMC, and Chevrolet or the SA9162C: remover/installer for Saturn to remove the power steering pump pulley.
Use the J 25033-C: installer for Buick, GMC, and Chevrolet or the SA9162C: remover/installer for Saturn to install the power steering pump pulley.
Ensure the axial tolerance of the power steering pulley on the shaft is within 0.25 mm (0.010 in).

Special Tools

J 25033-C: Pulley Installer
J 25034-C: Pulley Remover
SA9162C: Power Steering Pump Pulley Remover/Installer

For equivalent regional tools, refer to Special Tools .