Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Battery, Charging System And Starting System) >> Diagnostic Information and Procedures >> DTC P0615 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the following scan tool ECM parameters. The scan tool should display the status is OK.
    • Starter Relay Ckt Open Test Status
    • Starter Relay Ckt Short Volts Test Status
  2. Turn the ignition switch to the START position. Observe the scan tool ECM Starter Relay Ckt Short Gnd Test Status parameter. The engine should crank, and the scan tool should display the status is OK while the engine is cranking.
scientia non olet · About Mike's Workshop Manuals