Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine Control System & Fuel System - 3.6L - Repair Instructions) >> Repair Instructions >> Mass Airflow Sensor with Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Mass Airflow Sensor/Intake Air Temperature Sensor
    GM1858081Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF/IAT sensor seal (3) onto the MAF/IAT sensor.
  2. Install the MAF/IAT sensor (2) to the air cleaner assembly.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the MAF/IAT sensor screws (1).

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

  4. Connect the engine wiring harness electrical connector (4) to the MAF/IAT sensor.
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
scientia non olet · About Mike's Workshop Manuals