Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine Control System & Fuel System - 3.6L - Repair Instructions) >> Repair Instructions >> Knock Sensor Replacement - Bank 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Right Knock Sensor & Bolt
    GM860801Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Position the knock sensor and tighten the knock sensor bolt.

    Tighten:  Tighten the bolt to 23 N.m (17 lb ft).

    2. Fig 2: Identifying Knock Sensor & crankshaft position (CKP) sensor Electrical Connectors
    GM1860405Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (1) to the bank 1 knock sensor (2).
  3. Install the exhaust manifold lower heat shield. Refer to Exhaust Manifold Lower Heat Shield Replacement .
scientia non olet · About Mike's Workshop Manuals