Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Steering Wheel And Steering Column) >> Repair Instructions >> Intermediate Steering Shaft Boot Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Intermediate Steering Shaft Boot
    GM1856325Courtesy of GENERAL MOTORS CORP.
  1. Install the intermediate steering shaft boot (1).
    2. CAUTION: Refer to Fastener Caution .
    Fig 2: Identifying Intermediate Steering Shaft Bolt
    GM1853880Courtesy of GENERAL MOTORS CORP.
  2. Install the intermediate steering shaft to the steering gear and install the intermediate steering shaft bolt (1) and tighten to 22 N.m (16 lb ft).
    3. NOTE: Install intermediate steering shaft boot in the exact position it came out.
  3. Install the intermediate steering shaft boot to the steering gear and the intermediate steering shaft upper seal.
  4. Install the left front tire/wheel assembly. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About Mike's Workshop Manuals