Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 159 (Object Detection System - Park Assist System) >> Repair Instructions >> Rear Parking Assist Alarm Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2011 GMC Acadia, 2011 Chevrolet Traverse, and 2011 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Rear Object Sensor Housing
    GM1699865Courtesy of GENERAL MOTORS CORP.
  1. Remove rear bumper fascia. Refer to Rear Bumper Fascia Replacement .
  2. Disconnect electrical from the rear object sensor.
    3. NOTE:

    The rear object sensor is a one piece design. Do NOT twist the sensor cap to try and remove the painted cap. Replacement sensor requires painting to match fascia/bumper body color.

  3. Lift the locking tabs on the housing and remove the rear object sensor.
scientia non olet · About Mike's Workshop Manuals