Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Power Door Lock System And Release Systems) >> Repair Instructions >> Front Side Door Outside Handle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 GMC Acadia, 2011 Chevrolet Traverse, and 2011 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Outside Door Handle
    GM2476206Courtesy of GENERAL MOTORS CORP.
  1. Insert the outside door handle (1) to the handle housing.
  2. Slide the outside door handle back and forth to ensure fit.
  3. Install the lock cylinder cap to the door.
    4. Fig 2: Lock Cylinder Cap
    GM2528560Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution

  4. Insert a TORX #25 driver through the access hole to tighten the screw (1) retaining the lock cylinder cap (2), tighten the screw to 5 N.m (44 lb in)
  5. Install the access plug located in the upper inner door.
  6. Inspect the door for proper operation.
scientia non olet · About Mike's Workshop Manuals