Conditions for Running the DTC

DTC P0121, P0122, P0123, P0221, P0222, P0223, P0335, P0336, or P0338 is not set.
The engine speed is between 420-7, 000 RPM and steady.
The evaporative emissions (EVAP) leak detection is not active.
The delivered torque signal is greater than 5 percent at idle.
The delivered torque signal is between 6-29 percent with the transmission in drive.
The intake air temperature (IAT) is warmer than -30°C (-22°F).
The A/C compressor clutch is not changing states.
The ECM is not receiving a rough road signal.
The fuel level is greater than 11 percent.
The ECM is not in fuel cut-off or decel fuel cut-off mode.
The increase in engine speed is less than 2, 500-4, 600 RPM/second.
DTCs P0300 through P0306 run continuously when the above conditions exist for greater than 1, 000 engine revolutions. 200 revolutions after the first failure.