Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.6L - Introduction >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust >> Installation Procedure

Installation Procedure

    Fig 1: View Of CMP Sensor Bolt & Sensor
    GM1860459Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the CMP sensor (1) and bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    2. Fig 2: Identifying Intake & Exhaust Camshaft Position (CMP) Sensors
    GM1860428Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (7) to the bank 1 exhaust CMP sensor (6).
  3. Remove the engine mount strut and bracket. Refer to ENGINE MOUNT STRUT REPLACEMENT - RIGHT SIDE and ENGINE MOUNT STRUT BRACKET REPLACEMENT - RIGHT SIDE .
scientia non olet · About Mike's Workshop Manuals