Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Power Seat System >> Diagnostic Information and Procedures >> Lumbar Support Inoperative (Without Memory A45) >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the lumbar switch.
  2. Test for less than 1 ohm between the ground circuit terminal E and ground.
    • If greater than the specified value, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal G and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  4. Ignition OFF, connect the harness connector at the lumbar switch and disconnect the harness connector at the appropriate lumbar motor.
  5. Ignition ON, verify that the test lamp illuminates between control circuit terminal A and control circuit terminal B while pressing the lumbar switch in both directions.
    • If the test lamp does not illuminate for both directions, test the control circuits for a short to ground or an open/high resistance. If the circuits test normal, test or replace the lumbar switch.
  6. If all circuits test normal, test or replace the lumbar motor.
scientia non olet · About Mike's Workshop Manuals