Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> TrailBlazer 6.0 H, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 4.2L - Introduction) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating (MAP) Sensor Electrical Connector
    GM1922202Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector (1) from the manifold absolute pressure (MAP) sensor.
    2. Fig 2: View Of (MAP) Sensor & Screw
    GM1922215Courtesy of GENERAL MOTORS CORP.
  2. Remove the MAP sensor screw (1).
  3. Remove the MAP sensor (2).
  4. Inspect the MAP sensor seal for damage, replace as necessary.
scientia non olet · About Mike's Workshop Manuals