Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> TrailBlazer 6.0 H, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 4.2L - Introduction) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: View Of Crankshaft Position Sensor
    GM1237427Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the crankshaft position (CKP) sensor harness connector.
  3. Remove the CKP sensor retaining bolt.
  4. Remove the CKP sensor from the engine block.
scientia non olet · About Mike's Workshop Manuals