Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> TrailBlazer 6.0 H, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 4.2L - Introduction) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Camshaft Position Sensor Electrical Connector
    GM487648Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the CMP sensor and tighten the bolt to 10 N.m (89 lb in).
  2. Install the CMP sensor electrical connector (1).
scientia non olet · About Mike's Workshop Manuals