Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> TrailBlazer 6.0 H, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 5.3L & 6.0L - Introduction >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Top Of Engine Wiring Harness
    GM898326Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (6.0L) .
  2. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (3).
    3. Fig 2: Identifying MAP Sensor & Retaining Clip
    GM1509706Courtesy of GENERAL MOTORS CORP.
  3. Remove the MAP sensor retaining clip (2) from the intake manifold.
  4. Remove the MAP sensor (1) from the intake manifold.
scientia non olet · About Mike's Workshop Manuals