Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 913 (Cellular System, Entertainment System, And Navigation System) >> Repair Instructions >> Antenna Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear upper quarter trim panel. Refer to Rear Quarter Upper Trim Panel Replacement (Impala) .
    2. Fig 1: Identifying Antenna Cable & Radio Antenna Module
    GM1778658Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the antenna cable (1) from the radio antenna module (2).
  3. Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement (Impala) .
  4. Remove the rear seat back. Refer to Rear Seat Back Replacement (Impala) .
    5. Fig 2: Identifying Antenna Cable & Antenna Extension Cable
    GM1778655Courtesy of GENERAL MOTORS CORP.
  5. Remove the right carpet retainers. Refer to Front Carpet Retainer Replacement (Impala) .
  6. Remove the right lower center pillar trim panel. Refer to Center Pillar Lower Trim Panel Replacement .
  7. Adjust the carpet for access to the antenna cable as required.
  8. Disconnect the antenna cable (1) from the antenna extension cable (2).
  9. Cut off the visible end of the antenna cable from the wiring harness in the following locations:
    • The kick panel area
    • The rear shelf area
scientia non olet · About Mike's Workshop Manuals