Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 1089 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement (LE5) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator & Bolts
    GM1578425Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Position the generator to the engine block.
  2. Install the generator bolts.

    Tighten:  Tighten the bolts to 22 N.m (16 lb ft).

    3. Fig 2: View Of Generator Electrical Connectors
    GM1578426Courtesy of GENERAL MOTORS CORP.
  3. Install the engine harness terminal (4) to the generator stud.
  4. Install the engine harness terminal lead to generator nut (2).

    Tighten:  Tighten the nut to 20 N.m (15 lb ft).

  5. Position the rubber boot (3) over the stud.
  6. Connect the generator electrical connector (1).
  7. Install the drive belt. Refer to Drive Belt Replacement (LAT) or Drive Belt Replacement (LE5) .
  8. Install the air cleaner cover. Refer to Air Cleaner Element Replacement .
  9. Connect negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (LZ4, LY7, and LE5)  or Battery Negative Cable Disconnection and Connection (LAT) .
scientia non olet · About Mike's Workshop Manuals