Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.2L Or 2.4L - Introduction) >> Repair Instructions >> Accelerator Pedal with Position Sensor Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying APP Sensor
    GM1633085Courtesy of GENERAL MOTORS CORP.
  1. Install the APP sensor.
    2. CAUTION: Refer to Fastener Caution
  2. Install and tighten the APP sensor nuts to 10 N.m (89 lb in).
    3. Fig 2: Identifying APP Sensor Electrical Connector
    GM1633081Courtesy of GENERAL MOTORS CORP.
  3. Connect the APP sensor electrical connector (1).
  4. Install the insulator panel. Instrument Panel Insulator Replacement .
  5. Install the knee bolster. Refer to Knee Bolster Replacement .
scientia non olet · About Mike's Workshop Manuals