Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> HHR LS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 2.0L - Introduction) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Fuel Pressure Sensor & Fuel Pump Module Electrical Connectors
    GM1636698Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
  2. Disconnect the fuel pressure sensor electrical connector (4).
    3. Fig 2: View Of Fuel Tank Pressure Sensor
    GM1636702Courtesy of GENERAL MOTORS CORP.
  3. Position 2 flat-bladed screwdrivers, one on each side of the sensor, near the vacuum port.
  4. Using the screwdrivers as leverage, carefully pry up in order to release the sensor from the module.
scientia non olet · About Mike's Workshop Manuals