Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Equinox LS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 3.6L - Introduction) >> Repair Instructions >> Mass Airflow Sensor with Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying MAF/IAT Sensor
    GM1834958Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF/IAT sensor seal to the MAF/IAT sensor.
  2. Install the MAF/IAT sensor to the air cleaner assembly.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the MAF/IAT sensor screws.

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

    4. Fig 2: Identifying Engine Wiring Harness Electrical Connector
    GM1834957Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector to the MAF/IAT sensor.
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
scientia non olet · About Mike's Workshop Manuals