Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Chevy Express G3500, Van Passenger Extended >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 4.3L - Introduction) >> Repair Instructions >> Fuel Injector Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: When ordering new fuel injectors, be sure to order the correct injector for the application being serviced.
    Fig 1: Exploded View Of Fuel Meter Body Assembly
    GM1655471Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the NEW injector O-ring seals with clean engine oil.
  2. Install the fuel injector (2) into the fuel meter body injector socket.
    CAUTION: Refer to Fastener Caution .
  3. Install the injector retainer (3) and the injector retainer lock nuts (4), then tighten to 3 N.m (27 lb in).
  4. Install the fuel meter body. Refer to Fuel Meter Body Assembly Replacement .
scientia non olet · About Mike's Workshop Manuals