Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Chevy Express G3500, Van Passenger Extended >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 4.3L - Introduction) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.
    Fig 1: Removing/Installing Connector Position Assurance (CPA) Retainer
    GM1935684Courtesy of GENERAL MOTORS CORP.
  1. Remove the connector position assurance (CPA) retainer.
  2. Disconnect the electrical connector from the accelerator pedal position (APP) sensor.
  3. Remove the accelerator pedal bolt (1).
    4. Fig 2: Identifying Dash Panel Accelerator Pedal Assembly
    GM1935685Courtesy of GENERAL MOTORS CORP.
  4. Remove the accelerator pedal assembly (1) from the dash panel.
scientia non olet · About Mike's Workshop Manuals