Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Chevy Express G3500, Van Passenger Extended >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions (Battery, Charging System And Starting System) >> Battery Current Sensor Replacement >> Removal Procedure (Battery, Charging System And Starting System)

Removal Procedure (Battery, Charging System And Starting System)

  1. Disconnect the instrument panel (I/P) harness electrical connector (1) from the battery current sensor.
  2. Remove the negative battery cable. Refer to Battery Negative Cable Replacement (With LMM Primary)  or Battery Negative Cable Replacement (With LMM Auxiliary)  or Battery Negative Cable Replacement (With LY2, LMF or LY6)  or Battery Negative Cable Replacement (With LU3 and RVS) .
    3. Fig 1: View Of Battery Current Sensor
    GM1475086Courtesy of GENERAL MOTORS CORP.
  3. Cut the tie straps and electrical tape attaching the battery current sensor to the battery cable.
  4. Squeeze the negative battery cable branches together.
    5. IMPORTANT: Note the position of the battery current sensor prior to removal.
  5. Slide the battery current sensor (1) off of the negative battery cable.
scientia non olet · About Mike's Workshop Manuals