Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Chevy Express G2500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 4.3L - Introduction) >> Repair Instructions >> Knock Sensor 1 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Knock Sensor Wiring Harness Electrical Connector
    GM1950124Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Reposition the knock sensor sleeve down, away from the knock sensor, if equipped.
  3. Disconnect the engine wiring harness electrical connector (1) from the knock sensor.
    4. Fig 2: View Of Knock Sensor & Bolt
    GM1877015Courtesy of GENERAL MOTORS CORP.
  4. Remove the knock sensor bolt and sensor.
scientia non olet · About Mike's Workshop Manuals