Installation Procedure (Battery, Charging System And Starting System)
- Slide the NEW battery current sensor (1) up onto the negative battery cable.
- Using NEW tie straps and electrical tape, attach the battery current sensor to the negative battery cable.
- Install the negative battery cable. Refer to Battery Negative Cable Replacement (With LMM Primary) or Battery Negative Cable Replacement (With LMM Auxiliary) or Battery Negative Cable Replacement (With LY2, LMF or LY6) or Battery Negative Cable Replacement (With LU3 and RVS) .
- Connect the I/P harness electrical connector (1) to the battery current sensor.
IMPORTANT:
Ensure that the tape tab is pointing away from the battery prior to installation.