Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Chevy Express G2500, Van Cargo Extended, 6.6 6 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 6.6L LMM - DTC P1224 To DTC P2463 >> DTC P20E2 >> Circuit/System Verification

Circuit/System Verification

IMPORTANT: Determine the ambient temperature by using an accurate thermometer.
  1. If the ignition has been OFF for greater than 5 hours, determine which EGT sensor is skewed by comparing EGT Sensor 1 and 2 parameters to the ambient temperature with a scan tool. The readings should be within 19°C (66°F) of each other and also the ambient temperature.
  2. Ignition ON, observe the scan tool EGT Sensor 1 and 2 parameters. The readings should be between -40 to +999°C (-38 to +1,830°F) depending on the current ambient temperature and the vehicle operating conditions
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About Mike's Workshop Manuals