Repair Verification
- Install any components or connectors that have been removed or replaced during diagnosis.
- Perform any adjustment, programming, or setup procedures that are required when a component or module is removed or replaced.
- Clear the DTCs.
- Turn OFF the ignition for 90 seconds.
- Duplicate the Conditions for Running the DTC and use the freeze Frame/Failure Records, if applicable, in order to verify the DTC does not reset. If the DTC resets or another DTC is present, refer to the Diagnostic Trouble Code (DTC) List - Vehicle
and perform the appropriate diagnostic procedure.
- Ignition ON, engine OFF, observe the scan tool MAP and BARO parameters. The MAP and BARO sensor parameters should be within 5 kPa of each other.
- Engine running, observe the scan tool Soot Mass parameter.