Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Chevy Express G2500, Van Cargo Extended, 6.6 6 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 6.6L LMM - DTC P0016 To DTC P02E0 >> DTC P0101 >> Circuit/System Verification

Circuit/System Verification

  1. Verify that DTCs P0047, P0048, P0102, P0103, P0106, P0403, or P0405 are not set.
  2. Ignition ON Engine OFF, observe the scan tool MAP and BARO parameters. The MAP and BARO parameters should be within 4 kPa of each other.
    • If greater than the specified range, replace the MAP Sensor.
  3. Verify that restrictions do not exist in the exhaust system. Refer to Restricted Exhaust .
  4. Verify that leaks do not exist in the exhaust system. Refer to Exhaust Leakage .
  5. Engine operating at idle; observe the scan tool MAF Sensor parameter. The reading should be between 10-40 g/s depending on the ECT temperature.
  6. A WOT acceleration from a stop should cause the MAF Sensor parameter on the scan tool to increase rapidly. This increase should be from 10-40 g/s at idle to greater than 400 g/s at the time of the 1-2 shift.
  7. Operate the vehicle within the Conditions for Running the DTC to verify that the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About Mike's Workshop Manuals