Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Chevy Express G2500, Van Cargo Extended, 6.6 6 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 6.6L LMM - Introduction >> Repair Instructions >> Turbocharger Vane Position Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Remove the engine cover. Refer to Engine Cover Replacement .
    2. Fig 1: Identifying engine wiring harness electrical connector
    GM1731857Courtesy of GENERAL MOTORS CORP.
    NOTE: Note wire routing prior to removal.
  2. Disconnect the turbocharger vane position sensor electrical connector.
  3. Remove the turbocharger vane position sensor connector from the bracket on the LH valve cover.
  4. Fig 2: Turbocharger Vane Position Sensor
    GM1731868Courtesy of GENERAL MOTORS CORP.

    Remove the turbocharger vane position sensor from the turbocharger.
scientia non olet · About Mike's Workshop Manuals