Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Chevy Express G2500, Van Cargo Extended, 6.6 6 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 6.6L LMM - Introduction >> Repair Instructions >> Turbocharger Learn >> Learn Procedure With the Tech 2

Learn Procedure With the Tech 2

IMPORTANT: Once the enable conditions have been met the throttle must remain at idle. Do not change the accelerator pedal position (APP) during this procedure.
  1. The following conditions must be met for the ECM to perform the turbocharger learn procedure:
    • The A/C is OFF.
    • The vehicle is in Park or Neutral.
    • Start and idle the engine.
    • The engine coolant temperature (ECT) is greater than 40°C (104°F).
  2. After the enable conditions have been met and the engine idle is stabilized, enter the TC Learn Output function from the Module Setup Menu. Command the TC Learn ON for at least 5 seconds, then command it OFF. The system should have learned the new turbocharger position. The TC Vane Pos. Lrn This Run Cycle parameter should have toggled from No to Yes.
scientia non olet · About Mike's Workshop Manuals