Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Chevy Express G2500, Van Cargo Extended, 4.8 C >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 4.3L - Introduction) >> Repair Instructions >> Fuel Pulse Dampener Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Exploded View Of Fuel Meter Body Assembly
    GM1655471Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the NEW O-ring with clean engine oil.
  2. Install the fuel pressure dampener O-ring seal (5).
  3. Install the fuel pressure dampener (6).
  4. Install the fuel pressure dampener retaining clip (7).
  5. Install the upper intake manifold. Refer to Upper Intake Manifold Replacement .
  6. Tighten the fuel fill cap.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  8. Inspect for leaks.
    1. Turn the ignition ON, for 2 seconds.
    2. Turn the ignition OFF, for 10 seconds.
    3. Turn the ignition ON.
    4. Inspect for fuel leaks.
scientia non olet · About Mike's Workshop Manuals