Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2009 >> Chevy Express G1500, Van Cargo, 4.3 X >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 4.3L - Introduction >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Removing/Installing Crankshaft Position (CKP) Sensor Wiring Harness Electrical Connector
    GM1950052Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the engine wiring harness electrical connector (4) from the crankshaft position (CKP) sensor (3).
    3. Fig 2: View Of CKP Sensor & Bolt
    GM1877000Courtesy of GENERAL MOTORS CORP.
  3. Remove the CKP sensor bolt and sensor.
scientia non olet · About Mike's Workshop Manuals