Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2008 >> Uplander Base, 3.9 1 >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Diagnostic Information and Procedures >> DTC C0900 >> Circuit/System Verification

Circuit/System Verification

  1. Measure and record the voltage at the battery terminals with the engine OFF, and again with the engine running. Verify that the battery voltage is 11-16 volts with the engine OFF and with the engine running.
  2. Observe the scan tool Battery Voltage parameter in the EBCM data list. Verify that the scan tool displays a value that is within 2 volts of the battery voltage recorded in step 1.
    • If the scan tool parameter is not within the specified range, refer to Circuit/System Testing below.
  3. Refer to Diagnostic Aids above.
scientia non olet · About Mike's Workshop Manuals