Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2008 >> Uplander Base, 3.9 1 >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Diagnostic Information and Procedures >> DTC C0244 or P1689 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector X3 at the ECM.
  2. Ignition ON, test for 9.75-10.25 volts between the delivered torque signal circuit terminal 12 and ground.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the EBCM.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the EBCM.
  3. If all circuits test normal, replace the ECM.
scientia non olet · About Mike's Workshop Manuals