Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2008 >> Optra LS, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.0L (L34 GMDAT) - Introduction >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Refer to Battery Disconnect Caution .
    Fig 1: View Of Accelerator Pedal And Retaining Nuts
    GM1670940Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable.
  2. Disconnect the electronic throttle control (ETC) connector from the accelerator pedal.
  3. Remove the 3 accelerator pedal retaining nuts.
  4. Remove the accelerator pedal.
scientia non olet · About Mike's Workshop Manuals