Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2008 >> HHR LT, 2.4 P, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.4L - Introduction (2 Of 2) >> Repair Instructions >> Engine Control Module Replacement >> Removal Procedure

Removal Procedure

    Fig 1: ECM/TCM Cover
    GM1631889Courtesy of GENERAL MOTORS CORP.
  1. Using a scan tool, retrieve the percentage of remaining engine oil. Record the remaining engine oil life.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Remove the ECM/TCM cover.
    4. Fig 2: ECM Body Harness Electrical Connector
    GM1639226Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the body harness electrical connector (1) from the ECM.
    5. Fig 3: ECM Engine Harness Electrical Connector
    GM1639228Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the engine harness electrical connectors (1, 2) from the ECM.
    6. Fig 4: ECM Retaining Tabs
    GM1639229Courtesy of GENERAL MOTORS CORP.
    NOTE: Control module damage may result when the metal case contacts battery voltage. DO NOT contact the control module metal case with battery voltage when servicing a control module, using battery booster cables or when charging the vehicles battery.
  6. Disengage the retaining tabs (2) on the bottom of the ECM/TCM bracket in order to remove the ECM (1).
scientia non olet · About Mike's Workshop Manuals