Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2008 >> HHR LS, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2) >> Repair Instructions >> Knock Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Locating Engine Harness
    GM1622787Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the knock sensor (KS) harness electrical connector (6).
    3. Fig 2: Identifying Knock Sensor
    GM1578476Courtesy of GENERAL MOTORS CORP.
  3. Remove the KS bolt.
  4. Remove the KS.
scientia non olet · About Mike's Workshop Manuals