Removal Procedure

WARNING: This page is about a different car, the 2006 Isuzu Ascender, 2006 GMC Envoy XL, 2006 GMC Envoy, 2006 Chevrolet TrailBlazer, and 2006 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The console shift lever bezel must be removed prior to removing the traction control switch.

Remove the shift lever bezel. Refer to Console Shift Lever Bezel Replacement (Buick) in Instrument Panel, Gages, and Console.

Fig 1: Traction Control Switch Electrical Connector (Oldsmobile, Buick)

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical connector (1) from the switch.

Fig 2: Releasing Traction Control Switch Ring Tabs (Oldsmobile, Buick)

Courtesy of GENERAL MOTORS CORP.

Use a flat-bladed tool to release the ring tabs (1).

Fig 3: Removing/Installing Traction Control Switch Retaining Ring (Oldsmobile, Buick)

Courtesy of GENERAL MOTORS CORP.

Remove the retaining ring from the switch.

Fig 4: Removing/Installing Traction Control Switch (Oldsmobile, Buick)

Courtesy of GENERAL MOTORS CORP.

Remove the switch (1) from the trim plate.