Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2007 >> Silverado Classic 1500 HD, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Cellular System, Entertainment System, And Navigation System >> Repair Instructions >> Amplifier Replacement >> Installation Procedure

Installation Procedure

    NOTE: Refer to Fastener Notice .
    Fig 1: Locating Audio Amplifier To Floor Console Lower Bracket & Screws
    GM882649Courtesy of GENERAL MOTORS CORP.
  1. Install the audio amplifier to the floor console lower bracket.
  2. Install the amplifier screws.

    Tighten:  Tighten the screws to 3.4 N.m (30 lb in).

    3. Fig 2: Identifying Upper Console Bracket To Lower Console Bracket Screws
    GM1207763Courtesy of GENERAL MOTORS CORP.
  3. Install the floor console.
  4. Connect the floor console electrical connector.
  5. Install the screws (1) that retaining the upper console bracket to the lower console bracket.

    Tighten:  Tighten the retaining screws to 2 N.m (18 lb in).

    6. Fig 3: Console To The I/P Bolts
    GM1207835Courtesy of GENERAL MOTORS CORP.
  6. Install the bolts (1) retaining the console to the I/P.

    Tighten:  Tighten the bolts to 4 N.m (35 lb in).

    7. Fig 4: Locating Console Side Panel Screw
    GM1207752Courtesy of GENERAL MOTORS CORP.
  7. Install both front console side panel screws (1).

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    8. Fig 5: View Of Seat Track Trim & Rear Console Side Panel Screw
    GM1207757Courtesy of GENERAL MOTORS CORP.
  8. Move both front seats to the fully forward.
  9. Install both rear console side panel screws (2).

    Tighten:  Tighten the retaining screws to 2 N.m (18 lb in).

  10. Reposition the inboard seat track trim (1).
  11. Connect the audio amplifier electrical connectors.
  12. Connect the floor console electrical connector.
  13. Install the center console end panel. Refer to Center Console End Panel Replacement .
  14. Install the console storage bin. Refer to Console Storage Bin Replacement (Pro) or Console Storage Bin Replacement (Expect Pro) .
  15. Install the cupholder to the console. Refer to Front Floor Console Cup Holder Replacement (Luxury) or Front Floor Console Cup Holder Replacement (Non-Luxury) .
  16. Install the upper console bezel. Refer to Floor Console Bezel Replacement (Luxury Upper) or Floor Console Bezel Replacement (Non-Luxury Lower) or Floor Console Bezel Replacement (Non-Luxury Upper) .
  17. Install the radio amp fuse. Refer to Electrical Center Identification Views .
  18. If the amplifier has been replaced, perform the audio amplifier set up procedure for the BOSE™ amplifier with UQ7 and Y91. Refer to Audio Amplifier Setup .
  19. Refer to Control Module References for programming and setup information.
scientia non olet · About Mike's Workshop Manuals