Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2007 >> Optra LS, Standard >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Specifications And Ignition Switch Replacement >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Steering Column Cover Panel Screws
    GM1308107Courtesy of GENERAL MOTORS CORP.
  1. Install the lock cylinder.
  2. Connect the electrical connector for the immobilizer detection unit.
    3. NOTE: Refer to Fastener Notice .
  3. Install the upper and the lower steering column cover panel with the screws.

    Tighten:  Tighten the upper and the lower steering column cover panel screws to 2.5 N.m (22 lb in)  .

  4. Connect the negative battery cable.
scientia non olet · About Mike's Workshop Manuals