Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Suspension Control System - Suspension Leveling) >> Repair Instructions >> Air Compressor Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ALC shield (2) onto the vehicle.
  2. Install the ALC relay onto the vehicle. Refer to Automatic Level Control Relay Replacement .
    3. Fig 1: Locating ALC Shield Bolt
    GM898568Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the ALC shield bolt (1) and retainers to the vehicle.

    Tighten:  Tighten the bolts to 6 N.m(53 lb in).

  4. Install the ALC compressor assembly onto the vehicle. Refer to Air Compressor Replacement .
  5. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals