Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Cellular System, Entertainment System, And Navigation System >> Repair Instructions >> Digital Radio Antenna Cable Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Routing Antenna Cable
    GM859172Courtesy of GENERAL MOTORS CORP.
  1. Install the antenna cable retainers to the receiver bracket.
  2. Connect the antenna cable to the digital radio receiver.
  3. Attach the wire or string used in the removal procedure to the cable being installed.
  4. Carefully pull the antenna cable through the rear shelf into the passenger compartment.
  5. Install the right rear compartment trim panel.
  6. Remove the wire or string from the antenna cable.
  7. Route the antenna cable between the dome lamp harness and the upper quarter panel.
  8. Install the antenna cable to the dome lamp harness clips.
    9. Fig 2: Removing Antenna Cable
    GM859171Courtesy of GENERAL MOTORS CORP.
  9. Install the antenna cable retainer (3) to the rear header (2).
  10. Connect the antenna cable to the antenna base cable connector.
  11. Install the antenna cable mastic patch/tape at the roof.
  12. Install the rear of the headliner. Refer to Headlining Trim Panel Replacement (Impala) or Headlining Trim Panel Replacement (Monte Carlo) .
  13. Install the right rear upper quarter trim panel. Refer to Rear Quarter Upper Trim Panel Replacement (Impala) or Rear Quarter Upper Trim Panel Replacement (Monte Carlo) .
scientia non olet · About Mike's Workshop Manuals