Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2007 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Remote Power Steering Fluid Reservoir Bracket Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Power Steering Fluid Reservoir, Capstick, Bracket & Bolts
    GM663178Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering fluid reservoir bracket (5) into the vehicle.
    2. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the bolts (4) to the power steering fluid reservoir bracket (5).

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  3. Install the power steering fluid reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement .
  4. Bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About Mike's Workshop Manuals